Two things the packaging left behind. A verify that ran its 600-frame budget without the sensor being touched was reported to the client as verify-unknown-error. Nothing had gone wrong: nobody had pressed. It cost three verifications during packaging, each reading as a broken daemon. fprintd's contract is that a verify runs until the client stops it, so the frame cap bounds one trustlet scan session rather than the user's patience, and a window with no press simply runs again. Verified across the rollover: 600 frames untouched, "still waiting", then a press matching on its first contact frame in 44 ms. Presses that happen and never reach a verdict now report verify-retry-scan -- a bad scan, which fprintd has a word for, and not the matcher saying no. The cost is that an unanswered verify polls every ~200 ms for as long as the client holds it. The cure is measured and available -- gpio75 is silent at idle and bursts on contact -- but it would make the IRQ the only way a press is ever noticed, deleting the poll under every rate this daemon has been measured at. Noted where the loop waits, not done. And the trustlet: focal64.mbn is a proprietary OEM-signed blob, so the package ships a fp6-vendor-blobs manifest fragment instead, the same mechanism soc-fairphone-fp6-audio uses for the amp config. It needed a new directive there -- a QTEE image is an ELF header file plus one payload per program header, not one file -- and reassembly on the phone reproduces the image QTEE has accepted since August, byte for byte.
49 lines
2.4 KiB
Desktop File
49 lines
2.4 KiB
Desktop File
# SPDX-License-Identifier: GPL-3.0-only
|
|
# SPDX-FileCopyrightText: Copyright (C) 2026 Catcrafts®
|
|
[Unit]
|
|
Description=Fingerprint daemon (FocalTech FT9391 behind QTEE)
|
|
Documentation=https://forgejo.catcrafts.net/Catcrafts/fingerprintd
|
|
# The trustlet does the matching and it is a proprietary OEM-signed blob
|
|
# extracted from the stock vendor partition, so it is not in this package.
|
|
# Without it there is no sensor, and the unit stays out of the way instead of
|
|
# restart-looping.
|
|
ConditionPathExists=/usr/lib/firmware/focal64.mbn
|
|
# /dev/tee0 is the qcomtee driver, which the pmOS kernel does not build yet
|
|
# (CONFIG_QCOMTEE). modules-load.d asks for the module; this condition is what
|
|
# makes the package harmless on a kernel that has none.
|
|
ConditionPathExists=/dev/tee0
|
|
# The templates are QTEE containers on the Android persist partition, reached
|
|
# through the SFS root's persist-data/root3 symlinks.
|
|
RequiresMountsFor=/mnt/persist
|
|
Requires=dbus.service
|
|
# fp6-vendor-blobs reassembles the trustlet from the stock modem
|
|
# partition; it runs in sysinit so this ordering already holds, and
|
|
# saying so keeps the ConditionPathExists above from looking arbitrary.
|
|
After=dbus.service fp6-vendor-blobs.service
|
|
|
|
[Service]
|
|
Type=simple
|
|
# --edge-wake wait on the sensor IRQ instead of polling for a finger
|
|
# --sfs-writable QTEE must be able to WRITE the template store, or an
|
|
# enrolment cannot be saved. It can also unlink a container it
|
|
# rejects, which is why it is opt-in rather than the default.
|
|
# --rpmb-write the anti-rollback counter lives in RPMB; a save that cannot
|
|
# write it does not commit.
|
|
# No --verbose: it prints the frame-by-frame state machine, which on a phone
|
|
# is both journal noise and a record of when its owner unlocked it.
|
|
ExecStart=/usr/bin/fingerprintd --daemon --edge-wake \
|
|
--sfs-root=/var/lib/fingerprintd/sfs --sfs-writable --rpmb-write
|
|
# Root is required and not reducible: the daemon drives the sensor rails over
|
|
# gpiochip, holds /dev/tee0, and serves QTEE's RPMB transactions against the
|
|
# raw UFS RPMB device. No sandboxing is declared here rather than declaring
|
|
# some that was never tested against those three.
|
|
Restart=on-failure
|
|
RestartSec=5
|
|
# SIGTERM: the worker finishes the invoke it is inside before the session goes
|
|
# down; QTEE's listener table is global to the boot and a half-torn session
|
|
# leaves it holding ours.
|
|
KillMode=mixed
|
|
TimeoutStopSec=15
|
|
|
|
[Install]
|
|
WantedBy=multi-user.target
|