ipsec, engine, imsd: the state file records the P-CSCF and a resume follows the kernel's SA peer

A resume compared PCSCF= against the kernel's SAs and, when they did not
match, registered fresh without a word — a second initial REGISTER from an
address whose registration is live; on KPN a fresh pair to the same P-CSCF
meets the 21-minute refusal that costs the live registration (§13), what
another P-CSCF does with it is unmeasured. The registration was made to
whatever P-CSCF the SAs name (the SA setup takes imsd's previous pair
out first), so that is where a resume belongs: SaPeer reads
it from the dir-out transport policies — the one address a reqid-1 and a
reqid-2 policy both name, each with imsd's fixed protected port as its
selector's sport (reqid and mode alone are anyone's): the state text cannot tell the UE from the
P-CSCF, a lone policy is not ours and a VPN's beside the pair changes
nothing — TryResume resumes there, routes it, and says so when PCSCF=
differs; the next fresh registration moves to PCSCF= and moves back when
it fails before the SA setup and the old registration still stands (its
address still on the link), as it already did between addresses, and
its fallback Route is the P-CSCF it registers at, set before the 200's
Service-Route is looked for — an empty Service-Route value counts as
none — so a move never keeps the previous node's route. A file left by an attempt that got through the SA setup and did not live
to record — to this or another P-CSCF — is recognised by its SA pair: the
file's spi_uc/spi_us (a 0.3.x file carries them too) against the kernel's
(FileNamesAnotherPair, Imsd:Ipsec, pinned in tests/Ipsec), instead of
resumed with the wrong dialog; the state file gains pcscf, named in that
line. Both fresh paths — the bring-up's and recovery's — now set
their target themselves: with no PCSCF=, a bring-up that did not resume
fails with its own message, and since no fresh one follows: a resumable
pair whose attempt failed stays for the restart to resume, a pair nothing
can resume — one the engine's rule wrote off during the attempt among them,
a refresh refused with a 403 that carries a Retry-After or a binding a NOTIFY
terminated under the re-REGISTER wait, decided once after both catch arms by
its verdict (Reconnectable(), and with no fresh target Fresh(): a 401, a
refusal with a Retry-After, the second refusal — with no fresh target
every refusal reaches the reducer and its count travels in the holds, so
the restart's refusal is the second, while with a target only a
Retry-After does, as before — a refusal without one is not counted and the
fresh registration follows at once; without the count a refused no-target resume would re-REGISTER on the
same Call-ID at every RestartSec, the F16 loop) — is removed so the next
bring-up finds nothing — and a recovery step that needs one restarts the daemon; the "PCSCF not set" check at the top of BringUp is gone, so a
registration can be resumed with no setting at all. Three journal lines of
the fresh-target path change with it: `resume connect failed; falling back
to fresh` and `state file transport differs from SIP_TRANSPORT; fresh` end
in `the next registration is a fresh one`, and a resume the engine writes
off (a 403 with a Retry-After, a binding a NOTIFY terminated under the wait)
logs `resume failed: … — written off by the network: the next registration
is a fresh one` (§7.8). `no reg state file; resume falls back to fresh`
keeps its text with a fresh target and ends in `nothing can resume it: the
pair is removed` without one; the new `the state file names another SA pair
(0x…/0x…[ to X]) than the kernel's (0x…/0x… to Y): another attempt's; …`
line takes the same two tails.

Tested: crafter-build test, 7 passed (tests/Engine: the refusal count's travel
through the holds); the resume on the SA peer with
the fresh target absent in builds of this series on the dev
phone (KPN), and the no-target bring-up there with a resume that failed on
a transport mismatch (the pair kept, the restart resumed) and with the
state file removed (the pair removed, the next bring-up found nothing); the
two dead-resume lines' no-target tail — a missing file, a file with another
pair's SPIs — and the pair's removal on the tip's host build (bench 23f: a
fake modem on PATH, a real xfrm in a namespace; a file with the pair's SPIs
but another P-CSCF's address passes the check and the resume runs — `RESUME
via existing SA`, the connect then failing in the namespace); on the dev
phone (bench 41, the tip's build) a resume on a file without its pcscf key,
the live pair's SPIs.

tests/Engine/main.cpp

@@ -1097,6 +1097,20 @@ int main() {
             n.Restore(5, m.Holds(5));
             Check(!n.Reconnectable() && freshAt(n, 5, 0), "…so the next start registers fresh at once instead of resuming");
             Check(!RegRecovery::Held{0, 0, 21, false}.Any(), "nothing gone, nothing held: nothing to keep");
+            // the refusal count travels: a resume refused without a Retry-After at a start with no fresh target is one
+            // refusal, the restart's is the second — without the travel every restart would be the first (F16's loop)
+            RegRecovery rq;
+            rq.OnReconnectFailure(10, F::Refused, 0, 503);
+            auto hq = rq.Holds(20);
+            Check(hq.Any() && hq.refusals == 1 && !hq.oldGone && hq.hold == 0, "a refusal without a Retry-After is held as a count, nothing else");
+            RegRecovery sq;
+            sq.Restore(100, hq);
+            Check(!sq.Fresh() && sq.Reconnectable(), "the count alone gives nothing up");
+            sq.OnReconnectFailure(100, F::Refused, 0, 503);
+            Check(sq.Fresh() && sq.Reconnectable(), "the second refusal, across the restart, gives the resume up (fresh) without writing the registration off");
+            RegRecovery tq;
+            tq.OnReconnectFailure(10, F::Refused, 0, 401);
+            Check(tq.Fresh() && tq.Reconnectable() && tq.Holds(20).refusals == 1, "a 401 gives the resume up at once; its count travels too");
             RegRecovery x;
             x.Restore(2000, RegRecovery::Held{86400, 86400, 21});
             Check(x.holdUntil == 2000 + 3600 && x.freshHoldUntil == 2000 + 3600, "a restored hold is cut to the hour like the Retry-After it came from");