imsd

Userspace IMS/VoLTE daemon for mainline Linux phones.

Most Linux phones drive the modem's internal IMS engine. imsd implements the whole IMS client in userspace instead: SIP registration with USIM AKA authentication over kernel IPsec (ESP), call signalling, and the AMR-WB RTP media plane wired into PipeWire so a stock mobile dialer like Plasma Dialer or GNOME Calls under Phosh can place and receive real VoLTE calls on a commercial network.

Status

Call-capable, both directions: outgoing calls place, answer, carry full-duplex AMR-WB audio and tear down. Incoming calls ring, answer and carry media the same way, driven end-to-end from a stock dialer over a frozen D-Bus ABI. Not there yet: DTMF (SendDtmf is a stub), hold/multiparty/call waiting, USSD, P-CSCF discovery (the address is configured by hand).

Verified by community members to be fully working:

Device	OS	Carrier
The Fairphone (Gen. 6)	postmarketOS, Linux 7.1.2	KPN NL
The Fairphone (Gen. 6)	postmarketOS, Linux 7.1.2	Telekom Deutschland GER
The Fairphone (Gen. 6)	postmarketOS, Linux 7.1.2	Phonero
The Fairphone (Gen. 6)	postmarketOS, Linux 7.1.2	Telia Norge

What it needs

imsd talks to the modem through ModemManager plus qmicli over QRTR, installs its security associations with ip xfrm and plays audio through PipeWire, so in practice: a Qualcomm modem on a mainline kernel with working WWAN/ModemManager integration, kernel ESP, PipeWire, systemd, polkit and your carrier's P-CSCF address.

Install and configure

For automatic updates add the Catcrafts Alpine repository. Note this does also pull in other packages.

Otherwise just download the latest imsd and imsd-systemd APKs and install them.

Both can be found in the packages tab:

https://forgejo.catcrafts.net/Catcrafts/-/packages/alpine/imsd

Configuration is environment variables in /etc/imsd.env; the one required setting is the P-CSCF:

# your carrier's P-CSCF address, capture via: `adb shell dumpsys telephony.registry` on Android
PCSCF=2001:db8::105

The apk's imsd.service is enabled by preset and starts at boot once that file exists (the condition is checked when the unit starts, so after writing the file run systemctl start imsd). It first brings the ims PDN up through ModemManager, then registers: resuming an existing registration when it can, registering fresh otherwise, and waiting out whatever the network tells it to wait out. Check on it with:

journalctl -u imsd -f
busctl --system call net.catcrafts.IMS1 /net/catcrafts/IMS1 net.catcrafts.IMS1 GetStatus

Dialers

imsd itself is desktop-agnostic: everything a dialer needs is on the system bus as net.catcrafts.IMS1. A small translation daemon per desktop speaks the backend protocol its dialer already consumes, so dialer, shell and the call-history/contacts stack run unmodified.

Desktop	Daemon	Package	Owns	Consumed by
Plasma Mobile	imsd-dialerd	imsd	org.kde.telephony.* (session bus)	plasma-dialer + kde-telephony-daemon, replacing modem-daemon
Phosh / GNOME Mobile	imsd-ofonod	imsd-ofono	org.ofono (system bus)	GNOME Calls' ofono provider plugin

Plasma Mobile needs nothing beyond the imsd package: imsd-dialerd is autostarted in the session in place of plasma-dialer's modem-daemon, whose own autostart must be off — the package hides it for accounts created after the install (/etc/skel); an existing account hides it itself with a Hidden=true copy of org.kde.modem.daemon.desktop in ~/.config/autostart.

For Phosh and GNOME Mobile, apk add imsd-ofono enables imsd-ofonod and points GNOME Calls at its ofono provider (a gschema override; the per-user equivalent is gsettings set org.gnome.Calls autoload-plugins "['ofono']"). Do not run it alongside a real ofonod.

Call control is polkit's net.catcrafts.IMS1.Voice: the active local session and root may place, answer and end calls; an ssh login may not.

Full config:

Variable	Default	Meaning
PCSCF	(none — required)	P-CSCF address (IPv6); without it registration fails with a clear error
PCSCF_PORT	5060	unprotected SIP port for the initial REGISTER
DEV	qmapmux0.0	ims-PDN netdev; the packaged service passes the real one via /run/imsd.env
LOCAL	(auto)	UE address. The packaged service gets the PDN address ModemManager assigned, via /run/imsd.env from ims-pdn-up.sh; a manual run prefers a global IPv6 on DEV that is neither temporary nor dynamic (RA-derived), then any non-temporary one, then the first (the kernel's temporary SLAAC address is listed first, and a registration bound to it is lost when the kernel retires it)
USER_AGENT	imsd/<version>	REGISTER User-Agent. Some networks fingerprint UAs; setting your device's stock build string reproduces the stock modem's registration exactly. Empty omits the header
STATE_FILE	/var/lib/imsd/imsreg.state (root) / $XDG_STATE_HOME/imsd/imsreg.state	persisted registration context for warm resume
HOLDS_FILE	/run/imsd.holds (root) / $XDG_RUNTIME_DIR/imsd.holds (/tmp/imsd.holds without a runtime dir)	the waits the network imposed (a Retry-After, the refusal schedule), where that schedule stands and whether the old registration is gone (old_gone), kept across a restart of imsd for the PDN they were set on — not across a reboot; /dev/null switches the file off (only a regular file is ever removed; anything else is emptied). imsd-handover.sh honours it too
RESUME	auto	0 forces a fresh registration (ignores a warm SA)
REFRESH_INTERVAL	(auto)	keepalive re-REGISTER period in s; default = half the granted expiry, clamped to [120, 1800]
EALG	aes-cbc	offered ESP cipher (aes-cbc, des-ede3-cbc, null). From the 401's Security-Server list imsd selects the highest-preference ipsec-3gpp mechanism that matches this offer (RFC 3329 §2.3.1) and takes the SPIs/ports from the entry carrying them (some cores list every mechanism they support and put the SPIs on the one they applied); when no entry matches, the P-CSCF's SPI-carrying entry is installed as listed (hmac-md5-96, an absent ealg = null) and the journal says so. The line, the selection and the SA parameters are logged at every fresh registration
SIP_TRANSPORT	auto	transport of the protected leg (the second REGISTER and everything after it): tcp, udp, or auto = TCP, falling back to a fresh registration over UDP when the P-CSCF leaves two TCP connects unanswered — but only on a phone that has never registered over TCP: once the state file records a TCP registration, a silent connect is treated as an outage, not a policy (delete the file or set udp to override, e.g. after a SIM change). The challenge (first REGISTER) is always UDP. Over UDP a REGISTER or INVITE larger than ~1.2 KB leaves as IPv6 fragments at the ims PDN's 1280-byte MTU (the journal says so once per flow); there are no SIP retransmission timers over UDP yet, so a lost datagram costs a timeout. The SAs, the listener and the firewall rule cover both transports
EMERGENCY_NUMBERS	(empty)	comma-separated additions to the builtin 112/911 emergency numbers (e.g. a private test core's short code). SIM EF_ECC is not read yet. imsd-ofonod reads it too, for the oFono EmergencyNumbers property
RTP_PORT	50004	local RTP port advertised in SDP
PRECOND	0	1 offers SDP QoS preconditions
CODECS	(empty — defaults)	comma-separated codec preference list over AMR-WB, AMR (or AMR-NB), PCMA, PCMU: restricts and orders both the codecs offered on an outgoing call and those accepted from an inbound offer (default: offer AMR-WB + AMR, accept all four in that order). A bench knob — a network whose gateway transcodes every caller up to AMR-WB otherwise never lets the narrowband path run
DUMP_SIP	0	1 writes raw REGISTER-200/SUBSCRIBE-200 dumps, the last refused REGISTER or SUBSCRIBE final (imsd-register-fail.raw, imsd-subscribe-fail.raw), the last inbound INVITE (imsd-invite-in.raw) and the last outgoing INVITE (imsd-invite-out.raw), mode 0600, for debugging — they contain your IMSI/MSISDN and addresses. A refused REGISTER or SUBSCRIBE is logged with its status line and any Retry-After / Warning / Reason / Server headers
DUMP_DIR, OUT_DIR	state dir	where dumps / per-call media stats land
IMSD_MEDIA	(auto)	path to imsd-media (default: next to imsd, else /usr/libexec/imsd-media)

The protected client/server ports are fixed at 45061/45062 (imsd::util::PortUc/PortUs) — changing them in source also requires updating the firewall rules ims-pdn-up.sh installs.

imsd-media (per-call, set through imsd's environment)

Variable	Default	Meaning
MIC, PLAY	1, 1	uplink mic capture / downlink playout via PipeWire, as imsd passes them (imsd-media started by hand defaults both to off)
AUDIO_USER	(auto)	account whose PipeWire session carries call audio; imsd sets it per call from logind's seat0 session. Set in imsd's own environment it pins an account instead
GAIN, PLAY_GAIN	10, 1.0	uplink / downlink gain, as imsd passes them (imsd-media started by hand defaults GAIN to 1.0)
AMR_MODE	2	AMR encoder mode of whichever AMR codec is active, as imsd passes it (12.65 kbit/s for AMR-WB; imsd-media started by hand defaults to 2 for AMR-WB and 7 for AMR)
DTX	0	encoder discontinuous transmission
MEDIA_TIMEOUT	6.0	seconds of downlink silence before exit 3 (far-end-hangup signal)
RTP_DUMP	0	1 captures raw downlink RTP next to the stats file

D-Bus ABI

net.catcrafts.IMS1 at /net/catcrafts/IMS1. The ABI is frozen.

Member	Signature
Dial(number)	s → s (callUni)
HangUp(callUni)	s
Accept(callUni)	s
SendDtmf(callUni, tones)	ss
GetCalls()	→ aa{sv}
GetStatus()	→ a{sv}
CallAdded	s a{sv}
CallStateChanged	s s s (callUni, state, reason)
CallDeleted	s
RegistrationChanged	b

Both imsd-dialerd and imsd-ofonod are users of this ABI. A new desktop needs a new translation daemon, not changes here.

License

GPL-3.0-only — see LICENSE.

Copyright

Copyright (C) 2026 Catcrafts® catcrafts.net